a line maxi dress with sleeves Comfy A-line this dress is perfect for any winter occasion Vintage Cotton Long Sleeve Maxi

Dimensions Dimensions shown in diagram Preparation Shopping List 2 Sheets of 3/4" thick plywood and edge banding OR Shelf Help Carcass Kit 1 sheet of 1/4" plywood for back and drawer bottoms 5 - 1x4 @ 8 feet long 1 - 1x2 @ 6 feet long 1 - 1x8 @ 6 feet long 1 - 1x6 @ 6 feet long 1 - 1x12 @ 2 feet long 4 sets of 14" full extension drawer slides (affiliate link to Amazon) About 100 - 1-1/4" Pocket Hole Screws 1-1/4" and 3/4" brad nails wood glue 4 knobs or pulls primer and paint or desired wood finishing supplies Cut List Shelf Help Carcass Kit or 3/4" plywood panels, cut into pieces as noted below, front edge finished with edge banding 1 - 3/4" plywood @ 15-1/4" x 72" 2 - 3/4" plywood @ 15-1/4" x 35-1/4" 1 - 3/4" plywood @ 15-1/4" x 70-1/2" 2 - 3/4" plywood @ 15-1/4" x 31" Carcass Trim 2 - 1x4 @ 23" (bay supports, upper) 2 - 1x4 @ 70-1/2" (bay supports, lower) 3 - 1x2 @ 23" (drawer seperators) 1 - 1/4" plywood @ 34" x 72" (cut 34" instead of 36" so you can get the drawer bottoms out of the scrap wood) Drawers 6 - 1x4 @ 14" (drawer sides) 2 - 1x8 @ 14" (drawer sides) 6 - 1x4 @ about 20-1/2" - measure and cut to fit (drawer front and back) 2 - 1x8 @ about 20-1/2" - measure and cut to fit (drawer front and back) 3 - 1x6 @ 22-3/4" - (drawer faces) 1 - 1x12 @ 22-3/4" (drawer face) 4 - 1/4" plywood @ 14" x 22" (drawer bottoms) - cut the back for the project first, and then cut the drawer bottoms from the leftover plywood Instructions Step 1 Build the carcass, starting from the sides attached to the top, then the bottom attached to the sides, and finally the dividers attached to the top and bottom

Finish it with heels for an effortless all-day look.

Drawer interior: 13L x 28W x 5H(4), 13L x 13W x 5H(2), in inches

Sumissura has completely changed my mind about custom clothing